簡易檢索 / 詳目顯示

研究生: 陳拱北
Gong-Bei Chen
論文名稱: 利用線性調光方法進行LED驅動器特性分析與架構比較
The Study of LED Linear Dimming with LED Driver Hardware Architecture Analysis and Comparison
指導教授: 呂藝光
Leu, Yih-Guang
學位類別: 碩士
Master
系所名稱: 電機工程學系
Department of Electrical Engineering
論文出版年: 2014
畢業學年度: 102
語文別: 中文
論文頁數: 57
中文關鍵詞: LED驅動遲滯控制峰值檢測線性調光PWM調光
英文關鍵詞: LED driver, Hysteretic control, Peak detection, Linear Dimming, PWM Dimming
論文種類: 學術論文
相關次數: 點閱:402下載:5
分享至:
查詢本校圖書館目錄 查詢臺灣博碩士論文知識加值系統 勘誤回報
  • 本文提供在線性調光下直流電壓輸入輸出的變動對於高亮度LED電流精準度、頻率與亮度影響之分析,作為架構設計之依據。在調光的方法中脈波寬度調變調光(PWM Dimming)最廣泛的被使用,但是在調光至低亮度時會看見LED的閃爍現象。另外,線性調光方法可以有更大的調光範圍而不會在低亮度時閃爍,但是在調光至低亮度線性調光會產生色溫現象。
    從實驗及理論的結果進行分析顯示峰值電流控制(Peak Current Control,PCC)的LED驅動器雖然電路較為簡單,但是驅動電路的線性調光範圍較小,且對應輸入電壓與輸出電壓變化的電流控制能力較差,輸入或輸出電壓改變下LED亮度和電流也會一起改變。遲滯電流控制(Hysteretic Current Control,HCC)架構的LED驅動器和峰值電流控制比較線性調光範圍更大,在LED調節至較低亮度時調光較穩定,同時它對於輸入電壓與輸出電壓變化時LED的電流控制能力較峰值電流控制好,所以LED的亮度幾乎不會隨輸入電壓與輸出電壓變化而變動,但是在輸入輸出的電壓變化下電路的動作頻率也會跟著改變。本文將LED驅動電路的實驗結果分析給設計者參考數據比較各類型驅動器。

    This thesis studies the characteristics of LED linear dimming using Peak Current Control (PCC) and Hysteretic Current Control (HCC) methods. It provides the results of the luminosity control capabilities of LEDs and the effects of LED luminosity by changing the input/output DC voltage. According to the results of the experiments and theories, the circuit for LED driver for Peak Current Control (PCC) is simpler, but the range of its linear dimming is smaller. Additionally, the capability of LED current control with PCC is worse compared to HCC. The range of linear dimming is wider for the LED driver using Hysteretic Current Control (HCC). Moreover, its capability of LED current control for the change of input and output voltage is better than PCC.

    摘    要 i Abstract ii 表目錄 v 圖目錄 vi 第一章 緒論 1 1.1 研究背景與動機 1 1.2 研究方法及目的 2 1.3 論文架構 3 第二章 文獻探討與回顧 4 2.1降壓型轉換器 4 2.2峰值電流控制 8 2.3遲滯電流控制 10 2.4脈波寬度調變調光 12 2.5 線性調光 14 2.6 發光二極體 15 2.7 驅動器元件HV9910B 16 2.8 驅動器元件LM3401 19 2.9 驅動器元件LM3404 21 第三章 實驗架構設計 24 3.1 峰值電流檢測 24 3.2 峰值電流檢測結合固定截止時間 26 3.3 遲滯電流控制 28 3.4 遲滯電流控制結合固定導通時間 30 第四章 電路架構設計與實作 33 4.1峰值電流檢測與固定截止時間架構 35 4.2遲滯電流控制器與固定導通時間架構 41 4.3線性調光實驗 49 第五章 研究結論與未來展望 53 5.1研究結論 53 5.2未來展望 54 參 考 文 獻 55

    [1] W. K.Lun, K. H. Loo, S. C. Tan, Y. M. Lai, and C. K. Tse, “Bilevel Current Driving Technique for LEDs,”IEEE Trans. on Power Electronics, Vol. 24, No.12, pp. 2920-2932, Dec. 2009.
    [2] K. H. Loo, W. K. Lun, S. C. Tan, Y. M. Lai, and C. K. Tse, “On Driving Techniques for LEDs: Toward a Generalized Methodology,” IEEE Trans. on Power Electronics, Vol.24, No.12,pp. 2967-2976,Dec. 2009.
    [3] I.H.Oh, “An Analysis of Current Accuracies in Peak and Hysteretic Current Controlled Power LED Drivers,” IEEE Applied Power Electronics Conf., pp. 572-577,2008.
    [4] C.T.Chou C.L.Lee, C.J.Juan, T.L.Lin, M.J.Tsai, “Color temperature compensation for LED lighting illumination,” International Conference onMachine Learning and Cybernetics,pp.1784-1789,2012.
    [5] R.Redl, Jian Sun, “Ripple-Based Control of Switching Regulators—An Overview,” IEEE Power Electronics, Vol.24 ,No.12, pp. 2669-680, 2009.
    [6] G. Villar,E. Alarcon,F. Guinjoan,A.Poveda, “Quasi-optimum Efficiency in Output VoltageHysteretic Control for a Buck Switching Converter with Wide Load Range,”IEEE 36thPower Electronics Specialists Conference, pp. 2118-2125, 2005 .
    [7] B.Arbetter,R.Erickson,D. Maksimovic, “DC-DC converter design for battery-operated systems,” IEEE 26th PowerElectronics Specialists Conference, Vol.1, pp. 103-109, 2010.
    [8] Zhang Weiping, Xiaoqiang Zhang, Xusen Zhao,Yunchao Liu, “The Dynamic Analysis of Power MOSFET in Buck Converter,” IEEE 2nd Power Electronicsfor Distributed Generation Systems, pp. 275-280, 2010.
    [9] Yan-Mou Chen, Dan Chen, Chung-Ping Ku and Chun-Hung Lin, “Stability analysis of a constant off-time peak-current mode LED driver,”2013 1st InternationalFuture Energy Electronics Conference, pp. 580 - 584, Nov.2013.
    [10] Marn-Go Kim, “Error Amplifier Design of Peak Current Controlled (PCC) Buck LED Driver,”IEEE Trans.Power Electronics, pp. 1-8,2014.
    [11] Eunchul Kang and Jaeha Kim, “A single-stage off-line LED driver IC with hysteretic power factor correction control,”Applied Power Electronics Conference and Exposition, pp. 2368 – 2371,Feb. 5-9, 2012.
    [12] Xiaohui Qu, Siu-Chung Wong, Chi K. Tse and Zaijun Wu, “Contactless electronic ballast for high brightness LED lamps with mechanical dimming method,”2012 7th InternationalPower Electronics and Motion Control Conference, pp. 443 – 447,June. 2-5, 2012.
    [13] Liu YU, Jinming YANG, “The topologies of white LED lamps' power drivers,”Power Electronics Systems and Applications, pp.1 - 6, May. 20-22, 2009.
    [14] Jorge Garcia, Antonio J. Calleja,Emilio Lopez Corominas, David Gacio Vaquero,Lidia Campa, “Interleaved Buck Converter for Fast PWM Dimming of High-Brightness LEDs,” IEEE TransactionsonPowerElectronics,pp.2627 - 2636,Sept. 2011.
    [15] L. Svilainis, “Comparison of the EMI Performance of LED PWM Dimming Techniques for LED Video Display Application,” Display Technology, pp. 162 - 165,March. 2012.
    [16] Sandip Uprety, Hai Chen, Dongsheng Ma, “Quasi-Hysteretic Floating Buck LED Driver with Adaptive Off-Time for Accurate Average Current Control in High Brightness Lighting,” IEEEInternational Symposium onCircuits and Systems,pp. 2893-2896, 2011.
    [17] Wen-Ching Yang, Yu-Jen Chen,Chin-Sien Moo,“An Efficient Driver for Dimmable LED Lightings,” Industrial Electronics and Applications, pp. 2331 - 2336, June. 2011.
    [18] W.A. Rodrigues, L.M.F. Morais, P.F. Donoso-Garcia, P.C. Cortizo, S.I. Seleme JR, “Comparative analysis of power LEDs dimming methods,” 37th Annual Conference on IEEE Industrial Electronics Society,pp. 2907 - 2912,Nov. 2011.
    [19] Supertex inc,HV9910Bdatasheet
    [20] Texas Instruments,LM3401 datasheet
    [21] Texas Instruments,LM3404 datasheet

    下載圖示
    QR CODE